only one like it on the market! A precision machine that
cuts gaskets with speed and ease from all types of
non-metallic gasket materials. Vise-mount to bench and
crank those gaskets out.
• Quality made in the USA
• All parts are replaceable
• Rugged, durable cast iron and steel construction
• Cuts to 22" OD, to 62" OD (with accessory bar, see below)
• Used for cutting non-metallic materials
(NEW and COMPLETE) $617.83
M-3 cuts gaskets from 2 inch ID to 22 inch OD.
Extra center bars may be purchased for cutting gaskets
from 22 to 42 inch and 42 to 62 inch diameter. Width of
face from 0.250 to 7.000 inches inclusive. See REPLACEMENT PARTS for M3 Gasket Cutter.
Thousands of M3 Gasket Cutters are in use in plants,
ship yards, factories and shops around the world — and
have been for decades!
Punch a 11 / 32" hole (#11 punch) in material. Mount
blank on spindle. Set the
calibrated center bar to the radius desired, pull down
the lever to lower the top cutting wheel and turn
IMPORTANT DISCLAIMER: All information provided on this site is for reference.
Always perform your own tests and acquire further information to determine
product suitability. While we make effort to provide accurate information, we
cannot be held responsible for errors either of omission or typographical.
Allstate Gaskets assumes no responsibility for the use or suitability of any
Tel: (631) 254-4050 • Fax: (631) 254-4330
Allstate Gasket, Inc • 31 Prospect Place • Deer Park, New York 11729-3713 USA